Author Topic: 700 mounting ? (Read 3283 times)

dynamark · « **on:** May 29, 2006, 07:17:56 pm »

whats the best way to bolt this thing down i'm getting a plate from george but my trans has a out put on both sides ,guess the ? is should i put the sproket on the left or right and/or does it matter. oh yeah how far is the best from the rear axle ie..short chain /long chain to mount it .i'm trying a mock up and want to make sure everything is placed right

thanks to all

dynamark

George Herrin · « **Reply #1 on:** May 29, 2006, 07:55:33 pm »

Where it mounts long chain or short depends on the chassis and room it provides, naturally shorter is better but you must leave romm for changing sprocket sizes for different ratio's. And the plates we make puts the sprockets on the right side of chassis.

dynamark · « **Reply #2 on:** May 29, 2006, 09:44:32 pm »

thank you george that helps a ton .i just rembered that you cant slide the rear to adjust the chain hence the slack adjuster .you don't know how much head scratchin you saved me /but i'm sure you do

thanks as allways
dynamark

bob kinner · « **Reply #3 on:** June 28, 2006, 03:17:49 pm »

why is it better to have your sprocket on the right side ?

matt25001149 · « **Reply #4 on:** June 28, 2006, 03:26:14 pm »

nope it dont matter but on some 700s there is only one output shaft and that is on the right soo ya theres ur answer

creechfan · « **Reply #5 on:** July 06, 2006, 02:51:09 pm »

Could someone please direct me in the right direction to see a picture of one of these 700 tranny plates you are talking about. or could someone post one?

Thanks!!

-CreechFan

George Herrin · « **Reply #6 on:** July 06, 2006, 06:45:29 pm »

Here ya go

http://www.heymow.com/viewtopic.php?t=355

News:

Author Topic: 700 mounting ? (Read 3283 times)