***Picture request***
Well, I'm at that point of the build where I'm fabbing up the front & rear brakes on this silly money munching BP build. I have 2
MCP red anodized master cyl's . My problem is space....I don't have much room inside the frame for a pair of MC's, there's enough room for two, but not much and they can't be spaced out by much at all. When using a brake bias made for karts (
Righetti - KB060N), what would the spacing be on the two master's? If it's much more than 1/4" or so, then I will have to do something different. I've looked all over this forum and google isn't much help either. Hopefully someone has a similar setup that can snap a pic for me.
Also, what about a remote adjuster like you see on full size cars? I suppose those can be rigged up. Just haven't seen one on a mower setup. The bias will be down under the pan and will not be very easily accessible.
Thanks for any help,
~Joe