« previous next »
Pages: [1]   Go Down

Author Topic: Mukuni flat slides on intek  (Read 2385 times)

0 Members and 1 Guest are viewing this topic.

Offline zach87cp

  • Turf Warrior
  • **
  • Posts: 400
  • Karma: 2
  • Gender: Male
    • View Profile
Mukuni flat slides on intek
« on: July 11, 2015, 10:48:38 pm »
Is anyone running 28mm flat slides that would give me any pointers I tried about everything on these things it sounds great reving it up and as soon as you get on track and full throttle it ,it has about a 5 sec delay then it will take off good then does it again as soon as I let off .
Logged
Zach Rupert
Rupert Racing
Super Sportsman #87
Sponsored by ace racing engines .

Offline Jeff McKelroy

  • Professor Ducky
  • Turf Warrior
  • **
  • Posts: 890
  • Karma: 10
  • Gender: Male
    • View Profile
Re: Mukuni flat slides on intek
« Reply #1 on: July 12, 2015, 10:14:51 am »
Sounds like the pilot jet may be too small, or you need to click the needle up one notch...Do you have EGT/CHT? EGT is kind of critical to tune these right, in my book anyway...

ANYONE who races Mikuni need to buy the Sudco book. Look for it on Amazon.
Logged

Offline zach87cp

  • Turf Warrior
  • **
  • Posts: 400
  • Karma: 2
  • Gender: Male
    • View Profile
Re: Mukuni flat slides on intek
« Reply #2 on: July 31, 2015, 10:31:00 pm »
Sorry it's been awhile I tried bigger and small pilliot jets moved needles up and down .I'm gonna take it to a local atv shop and put it on chassic dyno till I figure it out lol
Logged
Zach Rupert
Rupert Racing
Super Sportsman #87
Sponsored by ace racing engines .
Pages: [1]   Go Up
« previous next »