Author Topic: 35 inch vanguard  (Read 2915 times)

0 Members and 1 Guest are viewing this topic.

Offline rookie14

  • Newbie
  • *
  • Posts: 9
  • Karma: 0
    • View Profile
35 inch vanguard
« on: December 20, 2014, 10:21:25 am »
I can't seem to get my vanguard jetted right at all. Is there somewhere I can buy an assortment of jets main/pilot both? I was running to lean on the bottom end at wot. Now im running too rich at high rpms. Could I fine tune it with a needle valve on the bottom of the float bowl?  If so where can I get a needle valve to fit it? Thanks

Offline Cheen1989

  • Newbie
  • *
  • Posts: 16
  • Karma: 0
  • Gender: Male
    • View Profile
Ben Cheeney

Offline rookie14

  • Newbie
  • *
  • Posts: 9
  • Karma: 0
    • View Profile
Re: 35 inch vanguard
« Reply #2 on: December 21, 2014, 02:19:47 am »
That fits the single barrel carb?

Offline Cheen1989

  • Newbie
  • *
  • Posts: 16
  • Karma: 0
  • Gender: Male
    • View Profile
Re: 35 inch vanguard
« Reply #3 on: December 23, 2014, 04:41:10 am »
I'm not sure beings that I have a double barrel carb. The bowls may be a bit different.
Ben Cheeney

Offline lil_broge

  • Newbie
  • *
  • Posts: 6
  • Karma: 0
  • Gender: Male
    • View Profile
Re: 35 inch vanguard
« Reply #4 on: December 26, 2014, 12:35:48 am »
That needle will work for the single carb too. You just have to remove the plug or the after fire solenoid.
Mike Broge
#08 OHV Intek Twin