Sorry for the mistake, thanks for straitning me out. My build is inspired by George Herren's single cylender mod. I already have a rear axel from a speedway go kart that is ready to bolt on. I have been given a John Deer with no motor and will at least use the tin for my project. There will probably be some steering linkage and other parts that I can transfer. Maybe it will have a good seat that I can use. Oh, did I say I haven't seen it yet?? The motor will run through a drum type clutch back to a jack shaft then to the 1 1/4 go kart axle. Since this is farming country there are a lot of pulling mowers but no racing mowers maybe I can start something!!