Author Topic: govenor & oiler (Read 4682 times)

Scott · « **on:** December 28, 2005, 09:32:34 pm »

Is it OK to remove the weights off of the oiling gear and weld up the hole in the block for the govenor rod?

George Herrin · « **Reply #1 on:** December 28, 2005, 09:54:25 pm »

Yes you can remove the weights, just pull the pins and they fall off but be sure to reinstall the gear its your oil slinger. And for the hole just as easy to tap it and run a bolt in it. Cost less too unless yopu have everything at home or work to weld it.
George

Scott · « **Reply #2 on:** December 30, 2005, 10:25:28 pm »

Thanks, has there ever been any problems with the nylon oiling gears, is there a need to upgrade, is there a better oiling gear out there?

George Herrin · « **Reply #3 on:** December 31, 2005, 01:06:01 am »

nope there is no upgrade and it works just fine

pusstang · « **Reply #4 on:** February 02, 2006, 12:28:59 am »

Does anyone have a pic of that oiling gear, b/c i have no idea what you guys are talking about!!!

News:

Author Topic: govenor & oiler (Read 4682 times)