Topic: RAGB

[gtpuller]

Does the verticle shaft in the peerless 1000 RAGB come out from the top of the gear box? I don't want to take it apart yet, but I would like to know. The exploded diagram seems to show that would be the case but I am not sure.

Thanks

Tim Johnson

[foolnhismoney]

I believe you just power it on side with mounting flange and can run it any direction that keeps the vent upright

[George Herrin]

you take the snap ring off and it comes out the bottom

[foolnhismoney]

sorry miss understood your question

[TeamScoot]

if memory serves correct, there is a snap ring on the top of the bevel gear (like George said) which will be the easiest, but there is at least one underneath the bottom bearing, so if you cant get to the one on the bevel gear, removing the bottom one(s) should allow you to take it out the top.

[gtpuller]

you take the snap ring off and it comes out the bottom

Thanks George

if memory serves correct, there is a snap ring on the top of the bevel gear (like George said) which will be the easiest, but there is at least one underneath the bottom bearing, so if you cant get to the one on the bevel gear, removing the bottom one(s) should allow you to take it out the top.

Yeah thats where the confusion was for me

Thanks

Tim