Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Mower Maniac

Pages: [1] 2 3 ... 8
1
Newcomers / Re: New Member from Colorado
« on: June 28, 2020, 09:09:59 PM »
I would look up Rocky Mountain Mower Racing Association on Facebook

2
Newcomers / Re: 22hp Kawasaki
« on: June 08, 2020, 04:17:09 PM »
One of the biggest problems in there arent really any parts

3
Briggs OHV & Vanguard / Re: 38 vanguard
« on: May 29, 2020, 12:45:15 PM »
I have heard of people doing it, but I have never done it myself because I dont run twins... You could try getting in touch with carrier performance because vanguards are his specialty










4
Coffee Shop / Re: Kawasaki engines
« on: May 13, 2020, 04:10:25 PM »
Kawasaki engines are good...

5
Want To Buy / Who Has It? / Re: billet dogbone and oppy arc flywheel
« on: April 15, 2020, 01:31:15 AM »
No, it's still available on arc last time I checked just out of stock currently

6
Chassis / Re: FXS Steering
« on: March 04, 2020, 06:38:58 PM »
Slacker chassis on facebook has a lot of pics for reference

7
There is mower racing out by you. They are Socal mower racing on facebook. We are racing together at the riverside county fair on the 22nd.

8
Chassis / Re: Frame reinforcement, arma rule change
« on: December 24, 2019, 04:59:58 PM »
could run angle...

9
Copper gaskets unlimited has gaskets for the opposed. You could take out the inner springs on the EC springs to make the spring pressure a little more mild.

10
Kohler Engines / Re: 4" bore Kohler Command
« on: September 30, 2019, 01:08:40 AM »
The biggest Midwest has is 92mm or roughly 3 and 5/8

11
Kohler Engines / Re: 4" bore Kohler Command
« on: September 29, 2019, 11:03:47 AM »
singles have

12
Briggs Flathead / Re: New guy with 40cu oppy wants to upgrade
« on: May 17, 2019, 11:37:32 PM »
you could try advancing the timing, and put a k and filter and velocity stack on it. Also, better exhaust... Less dramatic bends. If that doesn't seem like enough, you could try mild porting on the block.

13
Trannys / Axles / Wheels / Re: Parts for Sale
« on: November 16, 2018, 08:54:58 AM »
How much per trans?

14
Briggs OHV & Vanguard / Re: Hello, newby here
« on: October 31, 2018, 11:33:37 PM »
Yeah, sorry to say, but that is a vari drive. Not good for anything really. Have to run a manual to not run into a bunch of problems

15
Briggs OHV & Vanguard / Re: Hello, newby here
« on: October 30, 2018, 09:44:28 PM »
700 is the best for racing, but for your use you could use a peerless transaxle. the mst 205/206 ones have worked the best for guys running 3/4 transaxles in my club

Pages: [1] 2 3 ... 8
anything