Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Mower Maniac

Pages: [1]
1
Kohler Engines / Kohler command single vs honda gxv???
« on: May 19, 2018, 01:39:31 AM »
I am wondering what you guys think would work best. Both will end up costing me about the same when said and done, but the kohler will end up being a lot bigger than the honda, however, it is easier to make the honda a little bigger. I have seen lots of good things bout both so I don't know what to go with. This would be for a cp mower that weighs about 530 with me on it.

2
Briggs OHV & Vanguard / Forged Pistons for Intek Single
« on: December 17, 2017, 04:19:56 PM »
Does anybody make forged pistons big enough for a model 33. I have been messing around and I have found the a 4.6l big bore piston would work, but I would need to have a custom wrist pin hole put in, or bore out the hole on an arc rod for an .866 wrist pin.

3
Briggs OHV & Vanguard / Briggs vertical to horizontal conversion
« on: October 04, 2017, 06:41:04 PM »
Has anybody ever done this. A post on facebook showed up with an fxs with a horizontal 31ci, and I was wondering if anybody has done this, and how it worked?

4
Briggs OHV & Vanguard / Pressure lube vs splash lube
« on: September 23, 2017, 10:55:16 AM »
What is the difference on the cams between a pressure lube and splash lube.

5
Briggs OHV & Vanguard / Isky intek v twin cam
« on: September 13, 2017, 09:07:57 PM »
Does anybody by chance have the grind for an isky v twin cam too? Also, does the isky Tecumseh grind work for an intek twin?

6
Briggs OHV & Vanguard / Isky #95 grind
« on: September 10, 2017, 04:11:08 PM »
Does anybody have the Isky #95 grind specs for an intek Single cam?

7
Briggs OHV & Vanguard / Intek solid cam gear
« on: September 09, 2017, 07:51:28 PM »
Does anyone know when briggs stopped using the solid cam gear?

8
Tecumseh Engines / Tecumseh build price
« on: August 06, 2017, 10:56:34 PM »
What should a single cylinder Tecumseh 17hp cost for a medium build (Stock bore, pro port and polish, crank balance, milled head, bigger valves, cam, flywheel, and carb work)?

9
Kohler Engines / Kohler Command single build
« on: August 06, 2017, 08:56:53 PM »
Hi. I was recently looking at kohler build prices just to mess around and I was wondering if I could build a 30-35hp kohler more cost effectively than a briggs. I have a stock 33ci briggs with a flywheel as of now. Midwest super cub is willing to sell me a flywheel for 100 bucks. What would work better. If the kohler would be better, is there anybody who can port and polish a kohler head for a really reasonable price?

10
Briggs OHV & Vanguard / Isky cam for a 33ci briggs
« on: August 03, 2017, 05:28:24 PM »
Hi, how do I get ahold of isky to get my 33ci cam reground?

Pages: [1]
anything