Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - The Flying Farmer

Pages: [1]
1
Coffee Shop / My RC Spads
« on: May 11, 2012, 11:17:41 PM »
Hey Rooster, here are some links to some of them.

An FPV rig Im building, and pics of one of my wings














Page 3 is mine

2
Tecumseh Engines / Carb - Rebuild or Replace?
« on: March 27, 2012, 07:42:02 AM »
Hello,

I have an OHV17 204606B with a series 7 carb 640072

After pulling my mower out, I noticed my float bowl had a chunk of plastic broke out of it where the fuel solenoid mounts. I took the bowl off and epoxied the chunk back in just to get it started for the year.

It started right up, however, it wouldnt run over 1/3 throttle and was spraying fuel out my hood stack pipe. Upon removing the air filter, there was fuel in the bottom of the air intake. So I figured it was a stuck float. Upon removal, however, the float works good and can shut off flow. I need to see if the float is cracked and is filling up with fuel. Anyway, I want to replace the float bowl assembly 730639.
BUT, Ive found two kinds of replacement kits. One has a brass emulsion tube. Another has the plastic blue emulsion tube. Mine has the blue plastic emulsion tube.

Which one should I use? Blue plastic or brass?
Or should I just forget this carb and replace it with another one that is a bolt on replacement, like an older non emissions carb?

Thanks guys, this forum is so helpful!

Joshua W

Pages: [1]
anything