Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - laurw1

Pages: [1]
Briggs Flathead / Put a Sleeve in a Kool-bore Briggs engine?
« on: December 09, 2018, 02:21:40 PM »
Hey so I have a 25 Cubic inch horizontal briggs engine, it is a kool-bore, meaning the cylinder walls are aluminum, no cast ieon cylinder sleeve. Briggs never made a 25CI or 28CI horizontal briggs with a cast iron cylinder sleeve, but they made vertical engines that had them. Now heres the question, can i put a sleeve in this engine? Ive heard about people putting sleeves in their kool-bore engines, but I would like some advice about what machining I will have to do, where I would get the sleeve, etc.

Briggs Flathead / Do 28CI Horizontal Flatheads exist?
« on: July 30, 2018, 02:36:30 AM »
Hey all, so I've been looking around for 28 CI horizontal engines, and all I seem to find are 25 CI aluminum bore horizontal engines! Do 28CI horizontals even exist? If not, has one ever been made from parts?

Briggs Flathead / Are All Opposed Twin Blocks The Same?
« on: May 15, 2018, 10:17:17 AM »
Hey so I was wondering if say the blocks for the 40, 42, and 46CI blocks are all the same. I am asking because I have a 42CI 18HP opposed twin with a wrecked block, and a 40CI 16HP opposed twin thats all good, so I was wondering if I could swap the crank and rods from the 18HP and put them into the 16HP without having to mill the pistons?

Pages: [1]