Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - weepinwizard

Pages: [1]
1
Honda and Clone Engines / Gx390 with briggs coil
« on: May 18, 2014, 10:39:38 pm »
http://www.ebay.com/itm/RACING-GO-KART-WORLD-FORMULA-PVL-MAGNETO-7100-RPM-REV-LIMIT-COIL-SPARK-BRIGGS-/151000083448

Dose anyone know if it is possible to use one of these Biggs coils on a gx390. I am sure a homemade coil bracket would be needed to adapt it to the 390. I have dose some reeding on these coils and from what I understand is they have 4 pickups that pickup signals from the flywheel. Dose the briggs flywheels have 4 magnets than? Just wanted to know if it could be done on a 390 thanks damien.

2
Coffee Shop / Running a pull start
« on: May 15, 2013, 10:30:59 am »
hi everyone got some ?s.  I am going to be running pro-x class through ARMA. from what I gathered in the rools and from one of my other posts I can run a pull start in this class. what I wanted to know was has anyone used the Raceseng Adjustable Billet Flywheel with there pull start. this is the flywheel I am going to use for my 390 so I can run a pull start only. and is there anything bad that can happen from using a pull start. 

thanks damien

3
Coffee Shop / pro x wizard
« on: May 08, 2013, 02:05:46 pm »
hi everyone I am building a wizard to run in the pro x class. reading through the ARMA rules i am mixed up about if i can run a pull start only or do i have to run a battery and a starter. the rules are worded really strange and can be interpreted both ways if anyone knows for sure what the rule is can you let me know? rule reads ( starter and functional battery must be on board, either electric or pull rope in all classes except pro-x).

thanks damien

Pages: [1]