1
Briggs Flathead / Opposed pistons
« on: April 23, 2016, 02:27:05 pm »
Is it possible to go bigger than 31ci pistons in a oppy
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Briggs OHV & Vanguard / 40ci single
« on: March 16, 2016, 01:03:35 pm »
I saw a post about 40ci big bore kits for a briggs single from ron does anyone know what rod and piston combo it is. Or is it something only from him.
Sorry the post said 4inch big bore kits not 40ci. Of course I don't know how many ci a 4inch bore would make it.
Sorry the post said 4inch big bore kits not 40ci. Of course I don't know how many ci a 4inch bore would make it.
3
Chassis / Heim joints
« on: February 22, 2016, 05:03:36 pm »
When ordering the 4 heim joints for my spindles do u need a left and right side heim joints or just all left or right I know ones for steering arm need to get both but wasn't sure on one's for spindles.
4
Chassis / Size of front axle beam
« on: February 17, 2016, 08:14:20 am »
What size beam front axle does most people normally use I have a piece of 2x2 x1/4 inch tubing
Is that too too heavy overkill. What is normally used that I see. Thanks
Is that too too heavy overkill. What is normally used that I see. Thanks
5
Driveline / What type of trans
« on: February 09, 2016, 12:19:48 pm »
Iv been running a 700 in cp is there and performance advantages over having a 820 with 017 gearset are they fairly the same or would there be a big torque advantage one over the other .
6
Kohler Engines / Kohler opposed twin
« on: February 07, 2016, 11:16:46 pm »
Are parts avaliable for these like the briggs opposed or do they have to be custom made iv searched and found nothing. It's a vertical BTW
7
I'm building my own clutch setup I have a two pulley setup on grooved one flat. I was wondering what way should my clutch spring pull or does it mattery current setup my spring goes to the front of mower and I have my grooved pulley on the back of clutch and flat on on the front. I'm asking because I just upgraded from stock clutch setup and when I rev motor belt will come off not in gear
8
Briggs OHV & Vanguard / Briggs 31 head
« on: September 27, 2015, 06:38:48 pm »
When installing ec roller rockers on a briggs 31ci do u put the pushrod guide plate back in or leave it out
9
Briggs OHV & Vanguard / Where to drill pin for brass weights on 28 ohv crank
« on: September 19, 2015, 10:02:17 am »
I already had crank machined do u line up brass weights with weights on crank. The machine shop was telling me I would still have to take it and have them set by a machine shop. This is first set iv done.
Pages: [1]