Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - pulling hard

Pages: [1]
1
Briggs OHV & Vanguard / 18hp vanny crank?
« on: March 26, 2012, 09:20:19 pm »
I got an 18hp vanny horizontal shaft with a bad crank. A guy in my club has a vertical shaft motor with a bad piston and head he says I can have. The question is will his vert shaft fit in my horizontal block? Thanks for any help you guys can offer.

2
Briggs OHV & Vanguard / 18h vanguard build ?
« on: March 09, 2012, 09:39:31 pm »
i recently picked up a 18h vanguard horizntal shaft motor for my tractor and am looking to build it up but my clubs rules do not allow any after market cams or pistons,rods etc... but you can use factory parts. and i just not sure which ones will give me the best results. some people tell me put a 23hp cam in it, advance the timeing and go but im not that familiar with these motors. any help would be appreciated thank you

Pages: [1]