Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - DoNoHo

Pages: [1]
1
Coffee Shop / Ron's Rocket Parts
« on: June 30, 2014, 05:01:10 pm »
Trying to get in touch with Ron at Rons Rocket Parts. Need parts ! The phone number I have didn't work . Thanks. :dancing:

2
Racing Mower Builds / Super Mod Single
« on: July 09, 2011, 06:11:58 pm »
Started my super mod single, go and check it out.

          


here is the link--->   http://s536.photobucket.com/albums/ff327/DoNoHo/Super%20Mod%20Single/#!cpZZ1QQtppZZ24

3
Briggs Flathead / Oppie Twinn Mods
« on: June 13, 2011, 02:32:00 pm »
Rod installation I think this is right, i can see both marks on the rods. The 1 mark on top and the 2 marks on botton, hmmm, the flywheel is up.

      

I took a piece of choke rod .058 " and bent it so i could get into the rods, I think this is right also

        





Go here to see all the photos in albums

http://s536.photobucket.com/albums/ff327/DoNoHo/Oppie%20Mods/

4
Chassis / mow racer will not start
« on: July 08, 2009, 10:39:48 pm »
last night i hooked up the charger on the battery , when i got home went out and took the charger off went into the shop and knowiced the lights didnt come on, the braker off. reset the raker and lights came on O WELL

went back into the out building where the mow racer was and tryed to start the engine , hmmmmm, the engine didnt crank, hmmmmm looked at all the norm stuff,

starter makes noise and turnes so fast make my head spin.  LOOK THE STARTER TURNS BACKWARDS DUH.

upond looking and testing te battery when i hooked up the tester the hand sweeps backwards pasted 0 n volts not right, shorted out the battery witn a 30 fuse link boom burnet it into fast, hoook it all back up and the starter stills runs backward, hmmmm dammmmm, put a new battery in it and the starter turns the right way the hand showes 14 volts and all is good.

Mow Racer running and all is well


Has anybody seen a battery get the polerised backwards?, I put a fluke meter on the batery with red to red and black to black  It stated 13 volts - ,  not + or positive  BUT NEGTIVED --

By me over my head

LAtor DoNoHo

5
Racing Mower Builds / DoNoHo's Super Mod
« on: March 04, 2009, 10:48:11 pm »

Don't know when, where ,or how well its going to work but I think this is going to be more fun building then anything Iv ever built. Barr NONE.

The mow shop down the street gave this to me to have and hold.

      

The frame is boxed and long about 48 ".

   

got my frame work started


   


marked off the offset and got my new center line

       

Got my axle and brake caliper mount built

6
Chassis / front axle beam
« on: December 30, 2008, 07:39:01 pm »
I be looking for the link or the post of how to lower the front axle, i saw it and had it book marked but lost it wih the old Hard Drive DUH,

Help me find it ?
PLZ 

DoNoHo    :confused: :roll:

7
Racing Mower Builds / DoNoHo's First MowBuild
« on: September 14, 2008, 11:44:32 pm »
Think i got it this time.

Thanks George for the help and getting me stright on some of the rules.

OK here goes

My Frame






Some more views






The start of steering





my jackshaft



The front down under





The rear 600 3 speed





overall down under





8
Driveline / transfercase ? 917 Craftsman
« on: August 06, 2008, 10:18:02 pm »
what transfercase does the 917 craftsman with a v twin 22 hp have in it? 6 speed hi and low shifter, right side pully .


9
Driveline / one mans junk, and Im lost
« on: July 29, 2008, 06:19:24 pm »
I found this junkyard today and i am not smart enough to tell what is in it

Didnt know where to put this so i picked driveline, if need to move its ok

some help picking out a transaxle and if it will work

thanks,


www.dies-world.com/die/j1.JPG

www.dies-world.com/die/j2.JPG

www.dies-world.com/die/j3.JPG

www.dies-world.com/die/j4.JPG

www.dies-world.com/die/j5.JPG

www.dies-world.com/die/j6.JPG

www.dies-world.com/die/j7.JPG

www.dies-world.com/die/j8.JPG

www.dies-world.com/die/j9.JPG

www.dies-world.com/die/j10.JPG

www.dies-world.com/die/j11.JPG

www.dies-world.com/die/j12.JPG

the person that controles all this was gone, i was 7.5 miles from home and had no time to wait, going back this week to see if it can be bought



Pages: [1]