Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Alexjd00

Pages: [1]
1
Briggs Flathead / CARB ISSUE????
« on: June 28, 2014, 02:18:02 am »
My brother and i both run STOCK 12 horse governed Briggs and when we get into the corners the motor cuts out like it's not getting any gas. Then when we get back on the straight away it powers right back up. What can we do to fix this issue?? 

2
Driveline / Re: need some help on sproket and pully sizing
« on: October 10, 2010, 09:18:49 am »
am really not sure wat tranin it is.. i get it for "free"(my faver 4 letter world)..i will have to look in to it to see if i can figer it out...

3
Driveline / Re: need some help on sproket and pully sizing
« on: October 09, 2010, 10:33:16 am »
thaxz i will try that

4
Driveline / need some help on sproket and pully sizing
« on: October 09, 2010, 09:50:42 am »
Im runing a 12hp briggs  flaty(stoke for know). With a 3 speed tranny. Am runing 16in tires and the tracks we run for B.O.B are short but i would like to run bsmra in the spring.. What would be the best to use for a pulley set up and sproket sizes?

5
Driveline / pulley and sproket HELP???
« on: April 12, 2010, 10:06:20 pm »
looking for some help on what size pulley on motor and tran and sprocket from trenny to rearend...
im looking to get an 8:1 or close...

6
Briggs OHV & Vanguard / Re: 15 hp ohv help!!!
« on: March 26, 2010, 06:36:18 pm »
do u know wat the sep for the lash is off hand for a 15hp ohv

7
Briggs OHV & Vanguard / Re: 15 hp ohv help!!!
« on: March 26, 2010, 06:00:53 pm »
i will try that thaxz... if that dont work wat do u think i should dew?

8
Briggs OHV & Vanguard / Re: 15 hp ohv help!!!
« on: March 26, 2010, 09:14:03 am »
yes the piston is at tdc..is the push rods defernt from the 14 hp ohv to the 15 ohv..i get the push rods that are for the 15 hp but threre like .080 to short..wat push rods should i use

9
Briggs OHV & Vanguard / 15 hp ohv help!!!
« on: March 25, 2010, 09:14:24 pm »
i have a 15 hourse power over head valve with a 14 hp head on it..wondering what the valve lash should be?? i have push rods everytime i meASE it the valve lash is different...

Pages: [1]
anything