1
Coffee Shop / Re: USLMRA membership
« on: September 05, 2014, 03:30:45 pm »
Will paper Memberships filled out at the local Clubs be valid?
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
while you are modifying the fenders, remember you are now allowed to sink the seat into it to get the 13" seat height from the ground to the bottom of the seat. If you are going by the uslmra rules ofcourse
Owen,
How do you plan to "drill" the lightening holes in these gears? These gears come in two types -- heat-treated steel or powdered metal -- and both types are hard. Do you have access to special bits that will penetrate these metals, or maybe a laser cutter? You'll need to be careful not to affect the heat-treating of the gears, especially the teeth and the bores.
I'm not trying to trade this mower in, it was my great grandpa's first mower and I finally got it running after 30 years of just sitting around. So it's got some sentimental value. What part of Michigan are y'all from? I live in Rockford... That probably wasn't wise of me, now roosters assassins know where to look!
I used a cheetah bead seating tool and it worked on all of my other tire applications thank you for the input
do not buy the new coils they have rev limiter built in no good