Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Hrupka Farms

Pages: [1]
1
Briggs Flathead / 8hp briggs starter gear
« on: June 25, 2015, 11:51:35 pm »
I have a mildly built 8hp a cam billet flywheel dual valve springs and larger valves I dont know much about the parts because i just got a few boxes of engine parts and a few blocks. My question is when i go to start the engine if it backfires it just shreds the starter gear. Is it a starter shiming problem or is this a common problem because i was told that you arent able to get a high torque starter for these engines. Thanks

2
Briggs OHV & Vanguard / 15.5hp Briggs single ohv
« on: February 15, 2014, 01:57:21 pm »
I have a 15.5hp Briggs single ohv. It's set up for gp. When I try to throttle it nothing happens it just stays at idle. The thing has me puzzled. Any information would be helpful :confused:

3
Driveline / axles
« on: November 03, 2013, 01:21:02 pm »
i have a john deere 111 that i have bought that is half built. It has a 1" axle with the ends milled down to 3/4" for the rims. Im going to get rid of that and get aluminum rims and hubs. the only thing that im confused on is shoulf i get a 1" straight axle or a 1-1/4" axle.  :confused:

4
Briggs Flathead / 8hp governer removal question
« on: October 14, 2013, 09:38:26 am »
i have a 8hp briggs that im going to remove the governer on while thinking about it removing the governer is also removing the oil dipper will it be ok or is there something i can make or buy for an oil dipper

Pages: [1]