Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Harry J Gaines

Pages: [1]
1
Driveline / Re: what RAGB do i use???
« on: August 04, 2016, 02:15:32 am »
I use a peerless 1000 it's a 1 to 1 ratio and about bullet proof

2
Tires / Beadlock rim
« on: June 23, 2016, 01:51:03 am »
I am looking for a 8x8 beadlock rim with a 4 on 4 bolt pattern any advise where to get one

3
Tires / Re: 8" rims
« on: June 23, 2016, 01:49:22 am »
Call ec racing you can get 8x9 and 8x10 rims my buddy just got a pair of 8x10 from them they don't list them but do have them

4
Tires / Re: Tube size for Ec 8x8 rims
« on: June 15, 2016, 02:33:30 am »
We have to run tubes on the right side tires where we run I run 18 7.5 8 tubes in my 16 7.5 8 tires on the 8 by 8 rims and works flawlessly

5
Briggs OHV & Vanguard / Re: Briggs 33ci
« on: April 30, 2016, 03:12:39 am »
I am running the same motor on mine and run it up to 6500 rpm on long straits but usually keep it under 6000 rpm and mine is also a balanced stock crank

6
Briggs OHV & Vanguard / carb tuning question
« on: April 04, 2016, 09:45:49 pm »
I am installing a mikuni 34 mm round slide carb on my built 33 ci briggs single any idea what jets and tuning would be a good start

7
Driveline / orange crush triple disk clutch question
« on: February 26, 2016, 10:21:06 pm »
I am planning on a switch to an orange crush triple disk clutch what would be the best way to adapt it to pulley drive I was planning on welding a 5 " pulley to the sprocket is there a better way

8
Driveline / clutch
« on: August 07, 2015, 11:09:58 pm »
Has anybody ever tried an eletric pto clutch for racing

9
Driveline / Re: 40 chain
« on: August 03, 2015, 03:58:51 pm »
I have been using 320 wt. Gear oil for lube

10
Driveline / 40 chain
« on: August 03, 2015, 12:14:15 pm »
I am running 40 chain to the axle does anybody have any recommendations on what brand to use it doesn't seem to last very long before I have to pull links to shorten it up or does anybody know if I could use a motorcycle chain if any sizes are close enough to 30 chain

11
Briggs OHV & Vanguard / Re: walbro bore size
« on: July 28, 2015, 10:55:12 pm »
It's an older model before the soliniod on the bowl

12
Briggs OHV & Vanguard / walbro bore size
« on: July 27, 2015, 09:43:31 pm »
I have a walbro carb I picked I believe it's a 56 but can't find the markings on the bore would anybody know what the bore size is on a 56

Pages: [1]
anything