Heymow - Lawnmower Racing Forum
General => Coffee Shop => Topic started by: cerialsledder on August 07, 2018, 10:54:42 am
-
Hey guys, I'm having some chassis set up issues on my racer with a posi rear end. I've tried different camber adjustments but now I'm thinking tire pressures are what I need to adjust. The problem I am having is it is pushing pretty badly in a corner to the point where I have to spill a lot of speed to make the turn. Any suggestions to what I can do for tire pressures? I'm not sure what this would do and I don't have access to the track all the time since it's about an hour south of me.
Thank you much for the help
-
Do you have any Ackerman? Where is your toe-out?
Bert
-
Castor?
-
Different width rims too. Air pressure was maybe 25 on right rear for a loose track surface or up to 40 psi on a hard clay track and 2lbs on left rear
-
Yes, it is a good idea. And I have the same opinio
-
Do you have enough preload on front left should be around 20lb heavier than front right