Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - lawncheif

Pages: [1]
1
Coffee Shop / 24 hp intek
« on: July 11, 2013, 04:42:13 pm »
My step father has a grass cutter that smokes...but not until it gets warm. This is a 24 hp intek. He says one of the spark plugs looks so bad he is suprised it fires. Does this sound like it could be piston rings? Any help aperciated.

2
Briggs OHV & Vanguard / sence of #'s
« on: April 27, 2013, 08:46:18 am »
I understand some of you can make sence of #'s on an engine. I bought a new vanguard. I know its a 35 cu from the model # that's all I know. The guy I bought it from said he had bought it a few years back. I would like to find out actually how old it is. Can I determine that from any of these #'s model 350777 type 1137-E1 code99090611 any help would be appericiated thanks.

3
Coffee Shop / header evac
« on: April 15, 2013, 04:59:34 pm »
 wondered if anyone has ever tried to evacuate the pcv into a header. I understand the typical method is to use a catch can.  Any thoughts on this?4

4
Briggs OHV & Vanguard / vanguard crank.
« on: January 07, 2013, 10:42:36 pm »
Any oversized bushing so the small journal vanguard crank will work on a bigger journal block? Is there any chance an intek crank would work? Thanks for the help.

5
Driveline / ec billet trans pully
« on: July 25, 2012, 09:52:02 pm »
Having troubles keepin a belt on, when the engine reaches higher rpm. I think I have narrowed it down to possible the trans pully bore, being wollered a bit. I was wondering if anyone else has had problems with the bore on the billet pulley wearing/ wollering? Not to knock ec. I don't have a problem with tranactions so far. (Do I try drilling, and tapping for a set screw? Thanks for any help on this guys.

6
Briggs OHV & Vanguard / 31 cube briggs pushrod.
« on: July 16, 2012, 03:50:12 pm »
Hey guys, do the pushrods have to have a hole through them, for oil? Thanks for the help.

7
Briggs OHV & Vanguard / 35 cu vanguard
« on: May 29, 2012, 02:30:05 pm »
Hey guys can anyone tell me,  what to gap my piston rings at on a 35 cu vanguard? Thanks for the help.

8
Coffee Shop / 31 cu briggs single
« on: April 18, 2012, 09:17:30 am »
Hey guys, I was wondering what the going rate is for a 31 cu briggs single? Stock. Thanks.

Pages: [1]