Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - ashook

Pages: [1]
1
Briggs OHV & Vanguard / boring
« on: September 23, 2014, 08:27:28 pm »
Can you bore a 28'' briggs to a 31''? This will be the stock 31 piston. Will it give you more power?

2
Briggs OHV & Vanguard / stainless steel valves
« on: November 19, 2013, 10:19:35 pm »
Were can i get these valves for a 16hp twin vanguard

3
Briggs Flathead / flathead bore
« on: July 26, 2012, 10:44:31 pm »
Does a 20 over bore give more power then a standard bore

4
Briggs OHV & Vanguard / flywheel
« on: May 27, 2012, 03:30:38 pm »
Does anyone the part numbers for the billet ring gear and the steel hub for a 28'' briggs single cyl

5
Briggs Flathead / flathead cam for 28'' briggs
« on: April 11, 2012, 10:07:33 pm »
looking for a good race cam with bottom and top end

6
Driveline / 708b
« on: October 10, 2011, 05:58:28 pm »
 Does this have the steel gears in it thanks for any infor

7
Briggs OHV & Vanguard / piston
« on: September 11, 2011, 09:35:48 am »
what is the best piston and rod for a 28'' briggs ohv single and how do you check spring height thanks for any help on this

8
Briggs OHV & Vanguard / timing on single ohv briggs 28''
« on: April 17, 2011, 11:43:56 pm »
Were is the best place to set the timing on arc wheel if has a gteam cam and head cam?.It had a arrow on the cam two teeth below the factory dot and said set it there in line with the crank gear.

Pages: [1]
anything