8
« on: December 01, 2010, 08:57:24 am »
i already tried cleaning the carb, even tried a different carb altogether. results were almost identical. i checked the flywheel key just a little bit ago and it is fine. also checked for leaks in the intake, checked the plug and coil, made sure ground wire on coil wasnt interfering, checked the fuel pump filter and tank cap. the only problem i found at all was the bottom crank seal is seeping a little. im running the precision alt212 cam and i read somewhere on here that intake clearance should be .014. right now it is at .006. does anybody know the proper clearance after cam install? and can somebody please tell me what i am overlooking on my motor......i know it cant be anything thats too major because it wasrunning fine just yesterday