16
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
17
USLMRA Races / 2014 Rules
« on: March 01, 2014, 09:33:40 pm »
http://www.letsmow.com/rules-tech/offical-rules/
I just realized there wasn't a post sticked for the 2014 rules. Here is a link
I just realized there wasn't a post sticked for the 2014 rules. Here is a link
19
Coffee Shop / Lambrecht Chevrolet auction
« on: September 29, 2013, 08:44:13 pm »
http://blog.hemmings.com/index.php/2013/09/29/day-1-results-lambrecht-chevrolet-company-collection-auction/
Anyone else follow this story?? Amazing what some of the cars brought! They were selling JUNK for $20000!
This was 2 hours from me but I didn't go. Knew stuff would be stupid expensive. And too many people. I do know 2 different guys who went. It will be interesting to hear what they will have to say.
Anyone else follow this story?? Amazing what some of the cars brought! They were selling JUNK for $20000!
This was 2 hours from me but I didn't go. Knew stuff would be stupid expensive. And too many people. I do know 2 different guys who went. It will be interesting to hear what they will have to say.
26
Coffee Shop / 30 cube Vanny horizontal shaft.
« on: July 11, 2013, 11:51:34 pm »
I have a 30 cube horizontal shaft Vanny. Single barrel downdraft carb.
Are these desirable for FXT's?
It is on an auger so it is probably in need of a rebuild and has carb issues. I'm thinking about buying a new engine to put on it because I need it to be reliable. If I could sell it that would soften the blow of buying the new engine.
Runs great when it runs. But dies at the worst times!!!
Are these desirable for FXT's?
It is on an auger so it is probably in need of a rebuild and has carb issues. I'm thinking about buying a new engine to put on it because I need it to be reliable. If I could sell it that would soften the blow of buying the new engine.
Runs great when it runs. But dies at the worst times!!!
27
Driveline / Zach Kerber 1 1/8" clutch
« on: June 26, 2013, 01:45:50 am »
http://www.zkbrmachine.com/subcategory.php?category_id1=68
There you go!!! It is done!!! I've run it and it is awesome. High quality and very tune able.
This clutch won't spread the basket like others will under high horsepower and high RPM applications.
Solid steel and hardened.
520 chain sprocket.
Make sure to tell Zach I sent ya!!!
There you go!!! It is done!!! I've run it and it is awesome. High quality and very tune able.
This clutch won't spread the basket like others will under high horsepower and high RPM applications.
Solid steel and hardened.
520 chain sprocket.
Make sure to tell Zach I sent ya!!!
30
Post your Pics! / Quick look at what I'm building.
« on: June 09, 2013, 07:56:00 pm »
That's all for now!!!