Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Offroader96

Pages: [1]
1
Driveline / 3 bolt pattern hub?
« on: June 17, 2012, 10:07:28 pm »
I'm looking for a 3 lug hub keyed for a 3/4" axle, Has anyone ever seen these and where do you get them?

Thanks

2
Driveline / Clutch question
« on: June 11, 2012, 07:33:03 pm »
How is your clutch got to be mounted I have mine like this Will it work? I am running left clutch right brake



or does it have to be mounted like this does it even matter?

http://i48.photobucket.com/albums/f232/GeorgeHerrin/P1010003-2.jpg

3
Chassis / Front end
« on: June 08, 2012, 05:18:16 pm »
Can you do direct steering on stock front end? See anything wrong it just seem hard to turn and it turns good to the right but don't turn at all to the left just spins in end

4
Briggs OHV & Vanguard / Need a briggs expert
« on: May 10, 2012, 09:39:15 pm »
Okay I am having 2 problems, The first one is I can not seem to kill the motor. I can crank it with the key switch but can't kill it with it, I can unhook the main wiring harness and battery and it still don't die. The only way to kill it is to unplug spark plug wire. My second problem well I don't know if it's a problem or not but on the left cylinder it is running about 400 degrees and the other right is running about 150. Is that normal??

Thanks,
Russ

Briggs and stratton 25hp OHV V-twin

Any tips are welcome  ;)

5
Briggs OHV & Vanguard / 25hp V-twin
« on: May 08, 2012, 04:03:22 pm »
What do you set the spark plug gap to?

25Hp V-Twin OHV

6
Coffee Shop / What do you think about this?
« on: May 01, 2012, 09:07:45 pm »

7
Coffee Shop / V-Twin
« on: April 30, 2012, 09:52:18 pm »
Got it for $100.00 runs great got to take frame back, got at junk yard and it has a hydro and moves and all.




8
Chassis / Clutch/Pulley
« on: April 29, 2012, 08:14:34 pm »
How far apart should the pulleys be?



Learning to weld to don't laugh.

9
Driveline / Jack Shaft Question
« on: April 25, 2012, 09:12:46 pm »
Okay first less me say I HAVE USED THE SEARCH AND FOUND NOTHING. Now that is said I am going to be running a 930 transaxle and I am going to lower it. What size pulley should I run on mower motor,top of jack shaft,bottom of jack shaft,and transaxle. First build so and YES I HAVE BRAKES AND KILL SWITCH.

10
Coffee Shop / ACME Mower Sports
« on: April 10, 2012, 09:55:01 pm »
When do you get shipping information from them them 3 days still nothing.

Pages: [1]
anything