Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - jamie_guy3

Pages: [1] 2 3 ... 5
1
Tecumseh Engines / off topic \\tecumch steams ss12hp
« on: July 04, 2008, 06:12:21 am »
i just both a ss 12hp 1969 garden tractor and when i run it for a will and it get hot ,,it start blowing steam from the pipe under the carb what is doing that thanks

2
Briggs OHV & Vanguard / 17.5 briggs carb problem
« on: June 04, 2008, 07:57:22 pm »
i got a tilly 375hl big bore on my 17.5 ohv and when you throttle to the end it does not respond like it should like  it dies down and then it goes after   ,, my other 12 hp got the 56 stamp inside the carb and that won work like it should  good what should i do with my tilly

3
Driveline / not pushing,, witch sprocket are better
« on: May 20, 2008, 10:10:39 am »
i got 17.ohv briggs and 5" aluminum dirt track tire 11"inch tall in back,, my set up now is clutch titan 18 motor,, gear box is 1:1 ratio,, i put on a 36 sprocket ,,14 tooth and 36 axle,,if i  change my 14 to a 15 would it be better thanks

4
Driveline / 6 speed foote
« on: May 18, 2008, 08:22:49 pm »
is this tranny good for a racing mower,, i got a freebee it,s a murrey tt1 6 speed foward tranny ,,mod. 11hp briggs,, with 6 inch tire ,,drop,, what kind of pulley would work good with that mower thanks

5
Briggs OHV & Vanguard / tilly setting please help
« on: May 15, 2008, 04:10:51 pm »
tilly 374 hl big bore carb on a 17.5 ohv briggs no governor how do you set the needle on the side one needle is the low and other is the hight how many turns for setting ready to start it both need the information first thanks

6
Briggs OHV & Vanguard / starting to build my 17.5 hp ohv
« on: March 26, 2008, 10:13:44 pm »
i had both a 17.5 ohv last winter just starting now butt discovered with my tilly carb,, i need a intake ,,so i took one of my 10hp tec.. snow blower,, it was i great fit on bolt pattern 100% cylinder head,, i turn it up side down to the  front of motor A1 fits on tilly carb to and i am bringing more air in my motor,, when i finish my build going to take picture it,s hard we got 8 feet of snow this winter up till now see you guys later

7
Tecumseh Engines / rod torque
« on: November 06, 2007, 10:46:45 pm »
does somebody no the torque of a rod from a 12 ohv hori. motor i ade it but lost the paper thanks

8
Driveline / set up qestion
« on: July 12, 2007, 10:18:34 am »
i guys in 3 gear i have a 2to 1 ratio on my tranny i will be running a tranny perless #516 titan clutch on motor clutch drum is 16 teeth on rear will it will be 16" tire with a mod. 12hp briggs wat should be my tranny,and my axle set up for a normal set up thanks

9
Briggs OHV & Vanguard / cam
« on: May 23, 2007, 06:42:11 am »
does it matter if the cam does not have the compression release attached to the cam thanks

10
Driveline / star tecumseh kart big bubba
« on: May 22, 2007, 07:39:36 am »
were can i get the spring color engement chart for rpm for this clutch \star tecumseh kart big bubba clutch 1 inch bore shaft thanks

11
Briggs OHV & Vanguard / rod question
« on: May 09, 2007, 03:25:01 am »
is a model 26ci ohv 14.5 hp the same connecting rod lent and measurement as a model 31ci ohv 17.5 hp thanks

12
Briggs OHV & Vanguard / head ohv
« on: April 29, 2007, 07:11:11 am »
if hi putt a head from a model 267707 on a 31 series model does it bring up the compression

13
Driveline / top go kart wheel
« on: April 24, 2007, 03:55:25 pm »
i both a set of top go kart wheel 5"rims i measure the bolt pattern 2" center to center were do i get rear hubs for this thanks

14
Briggs Flathead / compression
« on: April 11, 2007, 07:48:20 am »
how much on compression in a stock 11 hp brigg

15
Briggs Flathead / gas question
« on: April 10, 2007, 10:43:19 pm »
did somebody haver trying to run cold gas in there carb not the gas from the tank because it hot when comming out going in your motor less response with hot gas then cold better response try making a litle box spine a pipe inside and then putt some dry ice they call it better response to motor same as a stock car like i do

Pages: [1] 2 3 ... 5
anything