Heymow - Lawnmower Racing Forum
Engine Help => Briggs Flathead => Topic started by: laurw1 on December 09, 2018, 02:21:40 pm
-
Hey so I have a 25 Cubic inch horizontal briggs engine, it is a kool-bore, meaning the cylinder walls are aluminum, no cast ieon cylinder sleeve. Briggs never made a 25CI or 28CI horizontal briggs with a cast iron cylinder sleeve, but they made vertical engines that had them. Now heres the question, can i put a sleeve in this engine? Ive heard about people putting sleeves in their kool-bore engines, but I would like some advice about what machining I will have to do, where I would get the sleeve, etc.
-
As long as theirs enough material in the block you should be able to sleeve it
-
Not trying to go-jack this post but Does anyone have a specific sleeve or part # for a sleeve I’m working on resleeving my 28 to a 31,
-
Not trying to go-jack this post but Does anyone have a specific sleeve or part # for a sleeve I’m working on resleeving my 28 to a 31,
Nvm searched around long enough and found my answer!
-
Melling csl 1147 is what I use
-
Awesome, thanks Paul