Heymow - Lawnmower Racing Forum

Engine Help => Kohler Engines => Topic started by: bighead9007 on February 03, 2017, 09:02:49 pm

Title: Kohler command
Post by: bighead9007 on February 03, 2017, 09:02:49 pm

Would a 40 mm carb be to big on a 52.5 cubic inch vtwin.

Title: Re: Kohler command
Post by: rook on February 03, 2017, 09:34:42 pm

I run a 38mm mikuni on my 28 cube single

Title: Re: Kohler command
Post by: cycloneracer on February 03, 2017, 09:49:46 pm

Depends on what's been done to it. 

I have 2 42mm mikunis on my 42 cube command. 

Title: Re: Kohler command
Post by: bighead9007 on February 07, 2017, 02:19:21 pm

Stroker 3" crank , billet rods , forged pistons ,kerber 301 lift roller cam, in the process of heads now, any advice.

Title: Re: Kohler command
Post by: cycloneracer on February 07, 2017, 06:47:52 pm

Get with Kerber.  He was going to sell a carb kit based off the ones on my mower. 

He can do manifolds for it as well. 

On a side note I don't think your engine is legal in any organization. It is too big.

Title: Re: Kohler command
Post by: bighead9007 on February 08, 2017, 06:47:00 am

Just a tad.we don't race round we go straight.

Title: Re: Kohler command
Post by: cycloneracer on February 08, 2017, 10:56:32 am

I see! 

Title: Re: Kohler command
Post by: bighead9007 on February 14, 2017, 08:15:28 pm

Thanks  for  all  the  advice .