1
Coffee Shop / jetting
« on: May 23, 2015, 09:16:59 am »
I have a LMT- 80 walbro carb. I would like to know what the main jet size & what would size it would be 12% bigger.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
With 6's in the rear I ran any where from a 15,16,17 on the tranny and 42,44,46 on the axle. 5 on the tranny 8 on the engine. All depends on the size of the track.Thank you for imfo that's in the MXR class @3600
update:He told me that to... Good luck
We've been contacted stating our parts will soon be shipped. I guess we will wait and see.
Anyone else out there experiencing this?
Sent 2 cams&cranks and order $1600 worth of parts back in April.
Was told the parts were ready to ship in June. Haven't had contact since august. Won't respond to emails, phone calls, texts or Facebook messages.
Need some info.
Tire size. 13"
Transaxle? Transmission? Which one?? 700 peerless
What has been done to engine? 12 hp built
Do some searching in the driveline section.
Need some info.Tires Are 13".. transmission is a 700 peerless & the engine is a 12 hp briggs flatty that's modified.
Tire size.
Transaxle? Transmission? Which one??
What has been done to engine?
Do some searching in the driveline section.
What are you running, and is it on the front or rear?In the front
Depends on application. on the front I prefer a 6.5 to a 7. On the rear I use a 7.5. On my prepared chassis (38") I actually prefer a narrower tire on the front either a 13x6.0-6 (if you can find them) on a 6.5 or a 13x5-6 on a 6.0 rim. It will give the mower a lower stance with less roll over on the right front and an actually "wider" stance. If you don't understand how I can't explain it to you.Thanks guys
Lester