571
Briggs OHV & Vanguard / Re: 44CID Intek
« on: July 31, 2009, 09:06:31 am »
I will do that, Thank ya 
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
572
Briggs OHV & Vanguard / Re: intek ARC flywheel/Stock Starter Problem
« on: July 31, 2009, 09:05:03 am »
The folks at ARC told me that I had to have the heavy duty starter to run with their flywheels. So after I spent the 250.00 bucks on it I am unpacking it at the garage, Mark (Parts manager at a local John Deere dealer) looks at it and said to me that it is just a stock heavyduty starter from Briggs. I dont know what the number is, but I will reserch it and let you know.
573
Briggs OHV & Vanguard / Re: E.c. Air filter for intek
« on: July 31, 2009, 08:52:38 am »
www.knfilters.com I use the stock shaped one. 33-2240 I think it keeps a nice stock appearance of the engine, and its a easy install.....
574
Briggs OHV & Vanguard / Re: 44CID Intek
« on: July 31, 2009, 08:39:56 am »
Do I just need a higher lift, or do I need a longer duration too? 
I have to explane this to my sponsor "aka" Mrsracingjohndeere55 
I found out if I get real technical she just kinda looks at me and says "ok"
I have to explane this to my sponsor "aka" Mrsracingjohndeere55 I found out if I get real technical she just kinda looks at me and says "ok"
575
Briggs OHV & Vanguard / Re: 44CID Intek
« on: July 29, 2009, 01:52:10 pm »
My 44 runs with the indians. I watch George run past me all the time......... George, Since I run a lower rpm than most, is there a cam avalable to work with the lower rpm's?