Heymow - Lawnmower Racing Forum
Engine Help => Kohler Engines => Topic started by: truckintyler on October 23, 2019, 09:31:08 pm
-
Would a single 42mm Mikuni HSR flat slide be ok or too big for a command twin 44ci with a cam and port job?
Or would two smaller flat slides like Keihin fcr be best . Not sure which direction to take .
-
The engine that Zach Kerber built me had 2 42MM mikunis on it. I think he sells a kit with the intakes and carbs. Check his website out.
-
What would the port work be like? Also what rpms? Cam?
-
just ordered the MWSC 6000 cast cam kit , rods and flat top pistons , rpms ?- this is my first open engine 6000-7500 rpm ?.
Head work -- pretty much will be an amateur job just cleaning up the ports , nothing like the port work you do micheal.
-
In that case the carb is more than likely going to be way too big. Try a 36 or a 38 instead. 36 would probably be perfect