1
Briggs OHV & Vanguard / Re: Vanguard head bolts
« on: August 07, 2019, 08:07:52 am »
661-1018 are the ARP M8 x 1.25 x 85 hex black oxide bolts
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Briggs OHV & Vanguard / Re: Cylinder machining vanguard
« on: September 25, 2018, 02:01:45 pm »
I did a 38ci motor used the Intec pistons and stock length ARC rods and my pistons were in the hole by .053 and with a .016 thick head gasket I came up with around 11 to 1 comp ratio. The Intec piston pin height was about .020 shorter than the factory piston. I can also tell you PVT. sells a rod that is .022 longer than stock if it helps you out.
3
Briggs OHV & Vanguard / Re: Isky cam for a 33ci briggs
« on: August 03, 2017, 09:07:32 pm »
I tried to get a hold of them early this year never got a call back or an answer. I went to Precision Cams.
4
Briggs OHV & Vanguard / Re: Bandolero's versus stock vanguard
« on: June 16, 2017, 09:52:43 pm »
They use the stock rod in those motors so you will need the 6275 rod.
5
Briggs OHV & Vanguard / Re: Cam replacement, motor poping out the intake
« on: April 25, 2017, 09:45:14 am »
Or a wiped cam lobe.
Pages: [1]