Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - mowcrastinator

Pages: [1]
1
Driveline / push pull cluch placement
« on: January 22, 2011, 11:28:15 am »
Do you guys run your cluch closer to the drive pully or the trany pully and why?

2
Non-Affiliated Races / Deer Run Speedway / Port Byron, NY
« on: May 16, 2010, 10:27:28 am »
Clay Oval
Race Every Sunday
Sign in by 12:30
Racing Stars at 1:00

Howlands Island Rd.
Port Byron, NY 13140

every other Sunday points race
Sundays in between that, run what ya brung

3
Chassis / BMI spindles
« on: May 08, 2010, 04:40:23 pm »
I would like to order a set of spindle plates to build my front end. I have a set of the u weld spindles from BMI. anyone know what the center to center of the hemi holes should be and where i can pick up a good set of plates to fit?

4
Briggs and Stratton 31H777 01120 E1 0303 127A

17hp avs?

Hitch? George? Huffyxx? Old Goat?


5
Chassis / How much does your mower weigh??
« on: January 14, 2010, 07:41:07 pm »
A good point has been made and now I wonder..... what is the average weight of a racing mower??

so lets start it...

How much does your mower weigh and what size engines on it? :roll:

6
Post your Pics! / First Build... What cha think?
« on: January 14, 2010, 03:50:41 pm »
Having a ball! i know a gotta change handle bars...
http://s1018.photobucket.com/albums/af304/jharkness1234/First%20Build/

Hope this works

7
Driveline / Clutch Set-Up / Single or dual??
« on: January 12, 2010, 01:54:52 pm »
I am running a 5" pulley on my engine and a 4-1/2" on my peerless 400. I only have about 14"s inside of pulley to inside pulley. My steering shaft is about dead center of that. So that means I have about 6"s between the steering shaft and trans. pulley on the slack side to mount a clutch.

Any suggestions on going with a dual pulley clutch vs. a single? (One stationary)
Pro's and con’s?
One work better in tight quarters?

Pages: [1]
anything