Heymow - Lawnmower Racing Forum
Engine Help => Kohler Engines => Topic started by: bodydropped72 on October 30, 2013, 11:41:02 pm
-
I just got an 18-20 HP twin from a generator I'm gonna be putting in a golf cart. The carb does not have any air/fuel adjustment. I assume this is a preset to run at 3600rpm. What kind of carb do I need to look for to where I can run this through an rpm range instead of the 3600 it was setup to run at
-
Do you have a billet flywheel for it??
owen
-
The governor does the speed control nor the carb
-
The carb you have is fine. It has a set linkage that you need to replace with your throttle control (gas pedal).
Lester
-
I got a carb like this on my puller, 24 584 053 I think is the part #, runs up to valve float with no
problems at all ( 5200 on my bone stock 18)
-
What does the throttle linkage look like that I need and where can I get one. I'm not sure about the billet flywheel. That's on the pull start side I'm assuming
-
You do realize that this engine has a tapered crank? I have heard of conversions but have never seen one.
Lester
-
Yes I'm aware of the tapered crank. I'm gonna use the armature from the generator side to make an adapter to fit
A polaris clutch.