Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - hotrod1

Pages: 1 2 [3]
31
Briggs Flathead / Re: just rebuild my 28
« on: April 11, 2011, 03:52:50 pm »
Thanks everyone. I think it might be my crank the bearings on the rod is bad. all scrached up. to much play.

32
Briggs Flathead / just rebuild my 28
« on: April 10, 2011, 04:57:40 pm »
I just rebuild my engine, and i was just idling it and it started to knock. I have new piston, arc rod and cam, brass weights, all the stuff. I even broke the engine in. Any idea what it could be. everything looks good when i open it up.
Tom.

33
Chassis / Re: Steering shaft support bearing
« on: February 15, 2011, 11:22:39 am »
You can use 1-1/4 emt electrical pipe

34
Driveline / Re: questions!!!
« on: November 02, 2010, 11:39:54 am »
Why do you want to do that. This site is all about safety. Know if you are going to race it the people will help you.

35
Briggs Flathead / Re: Fuel line
« on: June 24, 2009, 02:02:39 pm »
Thanks for all the input, i got it out by puttting the filling in the vice and using a rubber mallet, and it cam rigth out. and know i got a 90 coming in.
Thanks all
Tom

36
Briggs Flathead / Re: Fuel line
« on: June 23, 2009, 12:25:57 pm »
Thanks Huffy047, i will give that a try. i though of doing that but i figure i will as the question.
i dint want to damage the carb. it is new.





37
Briggs Flathead / Re: Fuel line
« on: June 23, 2009, 07:46:23 am »
it is a walbro carb.

38
Briggs Flathead / Fuel line
« on: June 22, 2009, 07:42:24 am »
Hi. i need some help on my carb, i have a streight fitting and it is prest in and i need to know how to replace it with a 90 deg fitting, i dont know how to get it out?

39
Tires / Re: Confused about fronts
« on: January 25, 2009, 08:21:31 am »
just change your spacers, remember 38" max

Pages: 1 2 [3]
anything