Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Hotroddy

Pages: [1]
1
Briggs OHV & Vanguard / ARC ring gear bolt torque loading figures
« on: February 14, 2024, 03:21:32 am »
What is the torque loading on the bolts holding ring gear on an ARC billet flywheel fitted to an Intek Twin

2
Briggs OHV & Vanguard / Re: Intek Twin cylinder Head bolts
« on: January 23, 2023, 02:14:34 pm »
Is using 49 head gaskets a good option for 44`s ? 49 gaskets look a lot stronger

3
Briggs OHV & Vanguard / Intek Twin cylinder Head bolts
« on: January 12, 2023, 02:27:45 am »
How much of a torque loading can the head bolts be tightened to ?

4
Briggs OHV & Vanguard / Re: Intek twin cylinder blocks
« on: August 19, 2019, 04:42:19 am »
Thanks for your reply.
Will look at increasing torsion strength of frame , and engine base plate .
Originally I thought engine block needed strengthening for extra hp

5
Briggs OHV & Vanguard / Re: Intek twin cylinder blocks
« on: August 18, 2019, 06:30:13 pm »
Recently we have seen 3 intek 40`s that have cracked the cylinder blocks . Not all on the same mowers . Anybody know why they crack and how to stop this problem ?

6
Briggs OHV & Vanguard / Intek twin cylinder blocks
« on: August 18, 2019, 03:23:45 am »
Is the cylinder block for the Intek 44 twin stronger than the 40`s

7
Briggs OHV & Vanguard / Re: Intek steel rocker arms
« on: May 07, 2019, 02:42:26 pm »
Is there any other steel rockers that will fit that have a better ratio ?

8
Briggs OHV & Vanguard / Intek steel rocker arms
« on: May 07, 2019, 04:00:26 am »
Can the original Intek twin rocker arms be replaced with original single rockers to give a better ratio ?

Pages: [1]