Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - silveradoboy

Pages: [1]
1
Briggs OHV & Vanguard / Re: 28 vs 31 blocks
« on: April 22, 2017, 08:26:24 am »
I always wondered about the difference. Thanks to help guys ill do some searching later.

Do y'all know if people cut and modify the engine cover to run a velocity stack and pod filter or do they run a 28 block cover?

silveradoboy

2
Briggs OHV & Vanguard / Re: 28 vs 31 blocks
« on: April 21, 2017, 08:20:16 pm »
What does the difference of avs mean? I have the avs block does that make a difference?

silveradoboy

3
Briggs OHV & Vanguard / Re: 28 vs 31 blocks
« on: April 20, 2017, 06:12:09 pm »
Thanks, I appreciate the help

silveradoboy

4
Briggs OHV & Vanguard / 28 vs 31 blocks
« on: April 20, 2017, 12:53:57 pm »
i have a 31a607-0741-b2 15.5hp ohv briggs engine and im trying to find a walbro lmt carb to put on it but cant figure out if one from a 28 block would fit. i dont care about the solenoid on the bottom of the carb because i plan to wire it out anyway, im trying to get away from the stupid nikki that is on the engine.

would a 698171 carb from ec fit? everytime i look at their site i shows it being a 28 block carb and not the 31 block.

and what is the biggest difference between the 2 blocks besides one being older than the other? will engine covers fit and internals be the same?

silveradoboy

5
im subscribing to this thread since i just picked up the same engine for free and thought i might build it up at some point.

silveradoboy

6
Newcomers / Re: noob
« on: February 18, 2015, 01:14:11 pm »
First off Welcome.   Next use the search bar.  Most every question you can think of has been asked and answered here.  Be patient and read.  If you do your research and read all the threads pertaining to your question FIRST then have questions the guys here can elaborate on it.  But you will find out the search bar is a very powerful tool if you just use it   

thanks man.

ill definitely use it, i used it alittle this weekend when i was trolling the page.

how many posts do i need to post something in the classifieds? cause im looking for a flathead carb

silveradoboy

7
Newcomers / noob
« on: February 18, 2015, 12:45:46 pm »
im new to the modifying briggs engines

im a member over at mytractorforum and sent me here, so i hope to find some good information

silveradoboy

Pages: [1]
anything