Heymow - Lawnmower Racing Forum
General => Newcomers => Topic started by: BsMowinFun on September 18, 2013, 05:44:22 pm
-
I am looking here at a peerless 700 and it looks like just 2 small shafts coming out each end so my guess is you need to use a right angle gear box (RAGB) then to the tranny then to axle is this correct? Thanks so much.
Never mind the gear box that was a dumb moment just run a normal pulley but how do you connect your tires to this do they make axles that bolt to this?
-
Check the build sections. You will see that with a 700 series tranny, you mount a solid karting axle either 1" or 1 1/4", a sprocket to the output shaft with a chain to the solid axle.
-
Oh ok thanks much. ;)