Hello I have been building another pulling tractor for the last little bit and I have attempted to go a different route this time than the usual narrow front wheels and tires. I recently bought a set of 5in Dia by 145mm wide polished douglas wheels. I am looking for the smallest tire I can mount to it. I wanted a turf tread or 5 rib style but so far all I have really found is kart tires. I have never used metric wheels on aything like this so I thought Id ask for some help. I figured about an 11x6x5 tire would fit but wasnt real sure and had no Idea where to find these tires except on ebay. If some one could enlighten me as to what sizes are available the smallest that would fit also as to where I could get them brand doesnt matter but price does Id like to get out as cheap as possible. They donot have to be new either so if anyone has a used set to sell pm me about them and Ill get back with you thanks Josh

Hello guys and girls I am nearing the point of figuring out what size belts I need. So I have a couple questions concerning this. My first question is what is the best way to measure for the belt dimensions I have 1 of the two belts off of my tractor that were original but It doesnt matter cause Ive changed the pulleys out and there all different dimesions Ive also Moved the trans  back 4in its not the stock trans either its from a different tractor so had to move it back and do plenty of cutting and restrengthening to make it fit. I know that no belt I have will even come close to fitting so Im trying to figure the best way to measure for one I was also woundering how the red belts are measured from the inner length or the outter length. I thought of a way I might could do it but Im looking for a better way the way I do it is hard to get accurate any way Thanks  for the help in advance Josh

Are Red belts really better than any other belts including Industrial belts. If so what makes them so much better and are they a sticky type belt. Was thinking of picking one up but woundering why I should.

Hi Guys I was woundering about a rod I have a horozontal shaft 25cu. flatty and I was wanting to replace the rod with one from an ohv engine. I was woundering what the part number for this might be or what the model nuber from an ohv engine is so that I could use that to look up the rod that I need. Thanks in advance for the help guys and keep in mind its a horozontal shaft engine I have. Thanks Josh

Any one know where I could get performance parts for my 10hp flat head engine. Like to find out also what parts may interchange from larger engines. I know some carbs will interchange from larger flat singles but other than that what. Thanks Josh

iv read that alot of guys are running rod bearings borrowed from wisconsin engines i have a K181 and i need to turn the crank and i was wanting to put a rod bearing on the rod does anyone know where i would be able to find these bearings so i could see which size i would need if theres one that would fit thanks

has any one built a massey ferguson mf8 ive got one i was thinking of pulling but it would be belt drive and i may want to build a racer it may be alittle mo fun to play with