Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Michaelgc7

Pages: 1 ... 11 12 [13]
181
Briggs Flathead / Re: Valve over lap
« on: September 20, 2012, 05:13:09 pm »
For sure  :D It got a little welded ;)

182
Briggs Flathead / Re: Valve over lap
« on: September 20, 2012, 05:07:49 pm »
It is an experimental cam..

183
Briggs Flathead / Re: Valve over lap
« on: September 20, 2012, 04:58:34 pm »
Thanks a bunch, couldnt be happier  :twothumbsup: :twothumbsup:

184
Briggs Flathead / Re: Valve over lap
« on: September 20, 2012, 04:49:48 pm »
Yeah thanks but it still kinda leaves me in the dark..

185
Briggs Flathead / Valve over lap
« on: September 20, 2012, 03:52:38 pm »
Hey, I have a question and I hope you guys can help me out. Is valve over lap bad? How much is too much? and is it okay depending on piston orientation?

Thanks, Mike

186
Driveline / Re: EC 700 tranny
« on: September 19, 2012, 05:24:43 pm »
Just brought it outside and tried it out, runs A1  :twothumbsup: :twothumbsup:

187
Driveline / Re: EC 700 tranny
« on: September 19, 2012, 07:06:38 am »
Thanks for all the help guys :thumbsup: :thumbsup: I feel confident now

188
Driveline / Re: EC 700 tranny
« on: September 18, 2012, 11:09:10 pm »
Okay and the oil has no problem getting to the end shafts anyways I'm guessing

189
Driveline / Re: EC 700 tranny
« on: September 18, 2012, 11:04:10 pm »
Okay thanks :) and why is it important to have a vent hole?

190
Driveline / Re: EC 700 tranny
« on: September 18, 2012, 10:45:31 pm »
So in other words 11hp @4000 rpm won't kill an EC  :P

191
Driveline / Re: EC 700 tranny
« on: September 18, 2012, 05:37:44 pm »
So if it under load its okay? Just not drop the clutch hard?

192
Driveline / Re: EC 700 tranny
« on: September 18, 2012, 05:15:14 pm »
Okay thanks  :thumbsup: and AHAHA

-Ive heard that many guys broke shift keys because of shifting on the go but thats all i know about the EC's cause i had a FOOTE before

193
Driveline / Re: EC 700 tranny
« on: September 18, 2012, 05:03:56 pm »
Cool thanks for the tips :) too bad a burnout could be tempting ;) Do you know what would cause the case to melt? and what oil is recommended? thanks :)

194
Driveline / EC 700 tranny
« on: September 18, 2012, 04:42:44 pm »
I currently installed the peerless 700 EC transmission into my machine. Since i have never used this transmission before I was wondering if there was anything that I should know before trying it out. Any info, tips or tricks are very appreciated.  ;D

Pages: 1 ... 11 12 [13]