1
Tecumseh Engines / Re: off topic \\tecumch steams ss12hp
« on: July 04, 2008, 05:14:39 pm »
thanks george your great help
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
2
Tecumseh Engines / off topic \\tecumch steams ss12hp
« on: July 04, 2008, 06:12:21 am »
i just both a ss 12hp 1969 garden tractor and when i run it for a will and it get hot ,,it start blowing steam from the pipe under the carb what is doing that thanks
3
Briggs OHV & Vanguard / Re: 17.5 briggs carb problem
« on: June 09, 2008, 06:52:42 pm »
i both that carb on ebay 375hl big bore it was new ,,should i try to find a smaller carb what kind should i get
4
Briggs OHV & Vanguard / Re: 17.5 briggs carb problem
« on: June 06, 2008, 01:00:13 pm »
with the big pipe on,, any were i set it does not matter if i shut the low side more idles good better response but not good gas goes in it stoles when i throttle more heaven if high adjust the high side going to weld a smaller pipe talk to you latter thanks
5
Briggs OHV & Vanguard / Re: 17.5 briggs carb problem
« on: June 06, 2008, 03:10:41 am »
George i just tried it to set it like you sad and it was worst i adjusted them after little bet at the time no different
going to change the pipe just let you no for up date as i am am going thanks
going to change the pipe just let you no for up date as i am am going thanks
6
Briggs OHV & Vanguard / Re: 17.5 briggs carb problem
« on: June 05, 2008, 12:33:30 pm »
pure stock reg gas i will change the pipe let you no after it is down thanks great help i got a timming key in stock one
7
Briggs OHV & Vanguard / Re: 17.5 briggs carb problem
« on: June 05, 2008, 09:46:10 am »
it,s from dead stop fuel i got lots ,when it idle there lots of orange flame comming out of my pipe the grass catch on fire ,,one thing i don,t no ,,if the muffler mabey to big,, i start with 11/4 is about 12"long ,,after goes up to 3" pipe for 6"long need more,, i will try to tell you more
8
Briggs OHV & Vanguard / Re: 17.5 briggs carb problem
« on: June 05, 2008, 05:33:57 am »
can somebody help how come my tilly does not respond like it should is the 375hl to big for that motor
9
Briggs OHV & Vanguard / 17.5 briggs carb problem
« on: June 04, 2008, 07:57:22 pm »
i got a tilly 375hl big bore on my 17.5 ohv and when you throttle to the end it does not respond like it should like it dies down and then it goes after ,, my other 12 hp got the 56 stamp inside the carb and that won work like it should good what should i do with my tilly
10
Driveline / Re: 6 speed foote
« on: May 21, 2008, 12:00:15 am »
are you runing a norma clutch 14 tooth what will be the sprocket on tranny in 5 gear ,,with 6 inch tire thanks
11
Driveline / Re: not pushing,, witch sprocket are better
« on: May 20, 2008, 12:57:16 pm »
yes if i put the 15 it will be better for top end thanks
12
Driveline / Re: not pushing,, witch sprocket are better
« on: May 20, 2008, 10:58:49 am »
somebody please
13
Driveline / not pushing,, witch sprocket are better
« on: May 20, 2008, 10:10:39 am »
i got 17.ohv briggs and 5" aluminum dirt track tire 11"inch tall in back,, my set up now is clutch titan 18 motor,, gear box is 1:1 ratio,, i put on a 36 sprocket ,,14 tooth and 36 axle,,if i change my 14 to a 15 would it be better thanks
14
Driveline / Re: 6 speed foote
« on: May 19, 2008, 08:04:09 am »
what kind of sprocket would go on the tranny and witch gear you will run with a norma clutch
15
Driveline / Re: 6 speed foote
« on: May 19, 2008, 03:33:34 am »
Here's another fine Foote...Believe it's a 4360 5 spped came out of a 93 Murrey ///////////]
it is a 6 speed like this one,, but i need some answer thanks ,,it for another build
it is a 6 speed like this one,, but i need some answer thanks ,,it for another build