3
« on: April 30, 2007, 07:42:59 am »
Hello,
I am planning out everything for a S/P Mowchine, So when I am home I have a headstart.
I am going to run a 28 cid briggs, haven't decided if I am going to have Don build a complete engine yet or just order the parts and put one together myself. What is a good RPM range for these engines? I ordered a tach the other morning, Digitron I think is what it was called, It is the one Cycloneracer uses and promotes as the tach of choice. I also have a 700 tranny sitting in the garage, that will be rebuilt. I am thinking of starting with a 6 inch front and 2 1/2 inch on the 700, will that work???. As for gears I don't know where to start, since I can't play hands on yet, but I've been reading that alot of guys are running 12's 13's or 14's on the tranny. On the rear thinking around a 40 or so, Going off what I have read on here. It will be easier to figure out when I am home and can do some actual tests. I am just trying to get a ideal range of everything.
Any help is much appreciated.
Thanks,
Spc. Leino