Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - moose

Pages: [1]
1
LeEarl,  as of right now i only have pictures of them on my phone, but i will work on getting some pictures with a camera and get them on here; Lee has seen pictures of them though.

Thanks for the info Lee. We will be trying to make Gilbert for sure, not sure about bagley yet, but we will try.          Moose

2
LeEarl, my friend and I both built FX machines this past winter.     Moose

3
Count me in! I'm glad to hear that there is going to be some racing close to home. I'm just finishing up the final details on my mower. Am i understanding right that this might be set up as a series possibly?

4
Related Events / Re: Midwest Build Clinic
« on: February 14, 2008, 12:32:52 am »
hey guys,

I just wanted to say thanks to Brian, Mark, Don, Lee, and everyone else who made the clinic possible. Great job! It was good to meet everyone and bounce some of my "new guy" ideas off of you. I am looking forward to seeing you guys at some races this summer. But over all the build clinic weekend was great, well, except for the part where my car broke down is Soux Falls, but thats a whole nother story inits self.
                                                                                                                                    Moose

5
Briggs Flathead / Re: 28 series Rods and Pistons
« on: December 31, 2007, 03:19:04 pm »
ok so i must have typed in half the piston assembly # and half the pin # , because somehow i typed it in wrong twice in a row.  :oops: ow it comes up like it should.    Tanks again guys,  Moose

6
Briggs Flathead / Re: 28 series Rods and Pistons
« on: December 31, 2007, 01:10:10 pm »
ok, thanks our listing must be wrong.  thanks again  Moose

7
Briggs Flathead / Re: 28 series Rods and Pistons
« on: December 31, 2007, 11:45:50 am »
   first off i sould like to say hi, i've just joined. i love the site TONS of great info, been read now for a few months. 
     
   my queston/problem being that i tryed looking up the pin (#697099) that fits the AVS piston assembly at work, and it comes up as a crank. i was wondering if possibly the part number is nolonger the same since you guys wrote the thread, or is our computer just wrong?  thanks,  moose

Pages: [1]
anything