1
Briggs OHV & Vanguard / model 28 vangaurd oil issue
« on: May 22, 2011, 10:00:25 pm »
have a model 28 vangaurd it runs great with no smoke and great compression, but once it gets warmed up it starts misting oil out from the bottom side of the breather vent. I have tried 2 different breathers and a new gasket and a used gasket with the same result. If this helps anyone out when i got it it would run great till warm then blow oil everywhere out of the breather, well it doesnt do that anymore due to the fact i think the oil level was to high. any suggestions? bothe surfaces on the breather and the block look good with no cracks or pits between surfaces