Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - BsMowinFun

Pages: [1]
1
Racing Mower Builds / Re: George's NEW BUILD for 07
« on: October 06, 2013, 09:40:05 am »
Got it. I am building mine to the tee the way you did. Step by step writing it all down now to take to the garage with me ;) Thanks George.

2
Racing Mower Builds / Re: George's NEW BUILD for 07
« on: October 06, 2013, 09:15:14 am »
Oh i see. So the new tires i purchased (Factory size) i can use just need new rims to bolt to the hubs right?

3
Racing Mower Builds / Re: George's NEW BUILD for 07
« on: October 06, 2013, 06:37:21 am »
George, This is so much what i needed to help me. I have the same exact MTD as this one and i pulley swapped it. Installed a foot throttle, removed the governor, and painted it. Looks good goes fast but its not safe and now i want to get into racing. I live in the heart of cleveland ohio and racing is a distance from my house or so i would think. Having this as a guide to doing thing the right way is what i needed. For you to take the time to do this just for your internet buds is an awesome thing. I am new so i am sure i will have questions for you. One thing is your tires? I thought the tires needed to be smaller in the rear for more speed? Maybe there is a thread on that? But thanks so so so much.
                                                                                    Fellow racer,
                                                                                         Brian!

4
Newcomers / Re: Need some help with transmission decision.
« on: September 19, 2013, 04:42:23 am »
Oh ok thanks much.  ;)

5
Newcomers / Need some help with transmission decision.
« on: September 18, 2013, 05:44:22 pm »
I am looking here at a peerless 700 and it looks like just 2 small shafts coming out each end so my guess is you need to use a right angle gear box (RAGB) then to the tranny then to axle is this correct? Thanks so much.
Never mind the gear box that was a dumb moment just run a normal pulley but how do you connect your tires to this do they make axles that bolt to this?

6
Newcomers / Please Help me! Im new to this
« on: September 13, 2013, 05:47:56 am »
I have an older 600 series mtd lawn tractor. I changed the motor pulley to a 5 1/2" and the trans to a 3 1/2" and i am not to concerned with racing just want to speed up a bit to like 30mph. I have the stock trans 618-0073 variable. What trans should i use? Any help would be great. Thanks so much.

Pages: [1]