intek 44 with a cheeta cam valve lash is set to .005 on I & E motor will turn over fine without plug & half turn with them in. would not having a hi torq starter cause it to not turn completely over?

I have really no idea on how to set a basic gearing for this thing. Im running a intek vtwin running a noarm 1600 series clutch chain driven to a 1:1 gear box what is a gearing ratio you guys run or how i should figure of gearing we run 125ft straights running 12x9-6 rear hoosiers

Is there a difference in shift keys(700 transmission) parts numbers 792089a and 792089b sears says its a direct replacement from the 792089a

Hello i am woundering is there any way to re fix the low end jetting on a nikki carb for a v twin i drilled the low end out and now its to rich and does not run well. I need to put the jets back to stock form. This is not like a Holley 650 carburator on a car its a whole different story im dont know much about it in the sence of the carburator if some one had a diagram on ever little bit of the carburator that would be very helpfull.

thx Ice Cream Man