1
Tires / sealing tires
« on: May 05, 2014, 09:22:48 am »
I'm having trouble getting tires to seal on the rims , any tips would be appreciated. May have to use tubes.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
3
Coffee Shop / Mower racing near Roanoke Va ?
« on: January 02, 2014, 08:21:25 am »
I have the same question, is there any mower racing near Roanoke Va.?
4
Driveline / belts and pulleys
« on: December 24, 2013, 04:02:11 pm »
I have started work on a build like Georges mod single with a 420 predator. It will remain stock for a while until every thing is working properly. No for the first question, Why can't I run a belt from the motor to the jack shaft and then put a shoe clutch on the output side of the jackshaft? Do you use the mower pulleys or say something from tractor suppily? What sizes would you suggest? What size belt, A or B ? Any input would be greately appreciated!! 
5
Driveline / First time build
« on: December 06, 2013, 12:46:52 pm »
This is my first time build and I may ask a lot of dumb questions. My drive line will be motor to ragb direct without a belt clutch. I intend to put a drum style clutch on the output side of the ragb and chain to a 1 1/4 go kart axel. I have everything except the ragb, so when
I make a trip to the junk yard, what do I look for?
Also are any mower races held in SW virginia where I could show up and learn??
I make a trip to the junk yard, what do I look for?
Also are any mower races held in SW virginia where I could show up and learn??
6
Tires / modified build
« on: November 15, 2013, 08:58:49 am »
I am going to start building a modified over the winter. as this is my first attempt I may start a little different than others. I come with a go kart background so I have many go kart parts among those are wheels of different widths. I'd like to know what wheel and tire size would be best using these wheels. I need to know this to set frame height before I start welding. Also I intend to build my own front axel and I need to know the deminsions of the end plates or where to buy same.
Caution, this is the first of many questions.
Caution, this is the first of many questions.
7
Chassis / What happened???
« on: June 23, 2013, 02:57:32 pm »
I started a new thread on a new build and asked some questions about wheels and tires and now my thread has dissappeared? 
Pages: [1]