16
Briggs Flathead / Re: No No not another carb thread you say
« on: October 08, 2021, 08:40:04 am »
Thier all over Ebay,just search for Briggs 12.5hp carb.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
heck, with the oppys being a dinosaur and everyone running V twins these days, I figured folks would have oppy stuff in piles in corners, collecting dust because nobody wants em....
Paul,my last one was a 5:1
It went...15 to 30 then
16-48
Now it's a smaller track,150-180' straights..clutch will most likely be a 15 tooth
Any sprocket tooth ideas?
Horizontal Briggs twin
That I'm not sure of, and I don't want to give not sure info. I have not heard that they are interchangeable but I have not run the 820 trans axle. When you call EC Carb ask them, they might know.Al ,if memory serves me right,I believe all the gears swap from an 820 to a 700 series trans,the input shaft does not swap though some 800 series had larger input shafts in them
bore size, depth, outside dimensions of the heads, i was considering to custom machine a new head.I'd say if you have the skills to machine a new set of heads,you probably should have the skills to do some measuring on the engine their going on.
Have any Walbro 100-506 for $10 in stock ?
Who made this style then ?
Thanks for the info guys I will give EC a call and see what I can find out . And yes Unfortunately the Indian guru’s are gone r.i.p, gota keep going on the Tecumseh’s .Good luck with that