Heymow - Lawnmower Racing Forum
Mower Building / Setup Help => Chassis => Topic started by: roesso on May 10, 2015, 08:38:57 pm
-
I was wondering how to build a steering arm on my spindle. I'm going to make mine direct steering.I looked at George 07 build but I can't see how it's set up. any help would be greatly appreciated
-
Weld an arm to the spindle.
There are a lot of ways to do it.
Look at the EC front axle. That will help you.
-
Thanks do I make the arm on my steering shaft and spindle the same . If so how long do they need to be
-
I was told: 2 inches on center on the steering shaft and 4 inches on center on the spindle
-
Could someone please post some detailed pictures
-
http://eccarburetors.com/store/en/precision-mower-accessories/front-axle-kits-parts/lawnmower-front-axle-w-hubs.html
There is a great example. You may want to consider purchasing one. It is a great unit.
-
Thanks if mine doesn't work out I will get one