Heymow - Lawnmower Racing Forum

Engine Help => Tecumseh Engines => Topic started by: MOWtivator on April 18, 2013, 10:00:53 pm

Title: i need a coil
Post by: MOWtivator on April 18, 2013, 10:00:53 pm

I am looking for a coil for my tech v twin...I believe its a 40 or 41 can anyone help?

Title: Re: i need a coil
Post by: redline on April 18, 2013, 10:06:31 pm

Techumseh only made one v-twin, and it's a 42ci. (well, if you go by model numbers, technically 3)
A stock coil?

Title: Re: i need a coil
Post by: MOWtivator on April 18, 2013, 10:25:30 pm

What if I am getting a billet fly wheel? Do I need a briggs coil..and thank you

Title: Re: i need a coil
Post by: George Herrin on April 18, 2013, 10:50:52 pm

Yup the intek twin or briggs single ohv or any briggs twin for that matter they all work if your getting a billet wheel You will also need a vanny coil wire harness or reverse the diodes in the original harness when using the briggs coils

Title: Re: i need a coil
Post by: wardee1977 on May 31, 2013, 08:38:00 am

I took some coils off a vanguard, and one of them would not work due to the plu wire being too short. Do the intek motors have longer plug wires? Or should I get a pair of ohv single Briggs coils?

Title: Re: i need a coil
Post by: Jim Knutson on May 31, 2013, 09:51:15 am

make sure you don't have the coil upside down, that's all i can think of.

Title: Re: i need a coil
Post by: wardee1977 on May 31, 2013, 11:36:21 pm

Got a set of coils off an intek twin today. The plug wire on them was about an inch longer than the vanguard coils. They fit perfect.